JHS Pedals JHS Buffered Splitter Guitar Signal Path Effect


There are so many reasons to add the JHS Pedals Buffered Splitter to your pedalboard. But the most important one is great tone. If you’ve ever split your guitar’s signal with a passive device, adapter, or even certain effects pedals, you know that the results can sometimes be less than stellar. This happens because many of those products simply cut your tone in two, sending one half one way and the other half the other way. You can end up with a tone that is muddy and lifeless. Adding our Buffered Splitter to your chain not only avoids these issues, but it will perfectly drive your long cable runs and pedalboard chains as well. Trust us on this one. If you need to split your signal for any host of reasons, putting our Buffered Splitter on your board will give you your tone back.


JHS Summing Amp Input Signal Blender Guitar Pedal


The JHS Pedals Summing Amp gives you the ability to take two inputs and blend them into one output. Simply plug into the two marked inputs and then plug in your single output and you’re ready to go. From two signals the Summing Amp creates one mono signal. This is perfect for putting effects in parallel so that they are not affected by one another. The Edge used this technique in the 80s with his delays. When you have a quarter note delay and a dotted eighth delay and you place them in parallel then sum them back together, the effect is that both delays come through more clearly and are not “delaying the delays”. This can also be used with overdrives so that they are not pushing each other as in series, but sit atop one another in parallel. Another use is combining fuzz and compression in parallel so the fuzz isn’t getting choked by the compression. The Summing Amp gives you the ability to use effects together in completely new ways that you may never have imagined and can open up new and inspiring sounds with your old effects. This simple little box takes two inputs and creates one output but it adds up to a whole lot more!