The A320 Personal Mixer from Aviom gives performing and recording musicians simple, intuitive control over their monitor mixes, allowing them to dial in the perfect mix themselves, without having to tell an engineer to change the mix for them.





Offering three-band master tone controls optimized for in-ear monitors, and the ability to monitor 16 mono or stereo sources with per-channel volume and stereo placement, the A320 gives musicians powerful control over their mix, while also preserving the simplicity required for use while performing.





The A320 also provides the musician a way to maintain specific mix settings consistently, night after night, and show after show. The unit includes space for eight mix presets, so you can save the perfect mixes for each tune, and recall them at will, to ensure reliable results in your monitors every time.The Aviom D400-Dante A-Net Distributor is a 2 RU rack-mountable device designed to deliver power and audio to up to eight Aviom personal mixers such as the A360, A320, A-16II, and A-16R.





The D400-Dante includes eight A-Net outputs designed for use with Aviom personal mixers. These eight outputs feature isolated (floating ground) DC power for providing remote power via Cat-5e to Aviom personal mixers. Additionally, it includes an unpowered A-Net Out, which can be used to connect additional A-Net Distributors, output modules, or other compatible devices.





The D400-Dante A-Net Distributor adds connectivity for a Dante digital audio network, allowing up to 32 channels to be sent directly from a Dante audio network to A320 and A360 personal mixers. Any 32 Dante channels may be selected from the Dante network using the Dante Controller software.





The D400-Dante is powered by an internal power supply, with a detachable power cord and IEC power inlet on the rear panel. The rear panel features a voltage selection switch that allows you to set the unit for 115 or 230 VAC operation. All network connections on the D400-Dante use RJ45 connectors.The MT-1a Mic Stand Mount from Aviom attaches to any standard mic stand to support the Aviom A360, A320, or A-16II Personal Mixer, or the A-16CS Control Surface. It attaches to the bottom of these products with three included screws and mounts on a mic stand with two supplied ring nuts.





The MT-1a can also be used with the Aviom EB-1 Extension Bracket, sold separately, to mount on the side of a mic stand instead of on top of it. The EB-1 is a right-angle bracket that secures along the shaft of a mic stand offset to the side, and the MT-1a then attaches on top of it with the same ring nuts.